Replace paper rolls in VeriFone and Hypercom terminals

This article describes how to replace a roll of receipt paper and the type of paper you need for the following terminals.

• VeriFone VX 680
• VeriFone VX 520
• Hypercom T4220, T4210, and T4205

VeriFone VX 680

Type of paper: thermal paper rolls, 2.25 inches wide, 50 feet long.

1. Pull the latch on the bottom of the terminal and lift open the paper cover.
   
2. Remove the old paper roll, if one is present.
3. Drop a new paper roll into the tray. The leading edge of the paper should be on the bottom and feed toward the top of the terminal.
   
4. Pull the leading edge of the paper about one inch or until all glue residue is past the edge of the terminal.
5. Close the paper cover.

VeriFone VX 520

Type of paper: thermal paper rolls, 2.25 inches wide, 50 feet long.

1. Flip open the paper roll cover.
   
2. Remove the old paper roll, if one is present.
3. Drop a new paper roll into the tray. The leading edge of the paper should be on the bottom and feed toward the screen on the terminal.
   
4. Pull the leading edge of the paper about one inch or until all glue residue is past the edge of the terminal.
5. Close the paper cover.

Hypercom T4220, T4210, and T4205

Type of paper: thermal paper rolls, 2.25 inches wide, 85 feet long.

1. Flip open the paper roll cover.
2. Remove the old paper roll, if one is present.
3. Drop a new paper roll into the tray. The leading edge of the paper should be on the bottom and feed toward the terminal's screen, as shown in the illustration in step 3 of the VeriFone VX 520 section above.
4. Pull the leading edge of the paper about one inch or until all glue residue is past the edge of the terminal.
5. Close the paper cover.